NORAC UC4+BC+AN2 - Manual (Page 31)

28
Figure 31: Cable Configurations: C10 and C11
2. Connect the UC4+ power cable (C10)
to the UC4+ Control Panel in the
sprayer cab. Ensure that both plugs
(P16A and P4) are connected to the
panel (Figure 31).
Ensure the UC4+ control panel’s
power is OFF for the remaining
installation (Bottom of switch
pressed IN).
3. Connect the 3-pin AMP connector (P3)
of C10 to an auxiliary power
connection inside the cab. If an
appropriate connector cannot be found,
it may be necessary to cut off the
connector(s) and splice into the existing
wiring.
For a clean connection to the
12V power supply, NORAC
provides optional power interface
cables.
4. For Electrically Teed Installation, please
read Section 4.8.1.
5. Route the receptacle end (R16) of C10
to the exterior of the cab.
6. Connect the 16-pin AMP plug (P16) of
the valve extension cable (C11) to R16
of C10 (Figure 31).
For a pull type sprayer, connect
at the hitch. This connection will
provide your hitch disconnect.