NORAC UC4+BC+AN2 - Manual (Page 32)

29
Figure 32: Cable Configurations: Electrically Teed Installation
Figure 33: Cable Configurations: Hydraulically Teed Installation
7. Route C11 to the rear of the sprayer
near the vicinity of the sprayer valve
block.
8. For Electrically Teed Installation, read
Section 4.8.1. For Hydraulically Teed
Installation, read Section 4.8.2.
9. Connect the 6-pin tower on the valve
cable (C3) to the mating 6-pin shroud
(S6A) on C11 (Figure 32/ Figure 33)
10. Install the 2-pin connectors from C03
onto the NORAC valve block (Figure
34).
11. The connectors on the valve cable
(C03) are marked RIGHT UP, LEFT
UP, RIGHT DOWN and LEFT
DOWN. Cables labeled with UP go
on the same side as the hydraulic hoses.