NORAC UC4+BC+AN2 - Manual (Page 20)

17
4.6 R
OLL
S
ENSOR
I
NSTALLATION
Mount the roll sensors to the included
roll sensor brackets using the machine
screws and nylon lock nuts, as
illustrated in Figure 17.
The roll sensors must be
mounted tightly to the brackets.
If your sprayer is a trapeze style
pivoting boom (the boom hangs
from two link arms) then follow
Section 4.6.1 to install the roll
sensors.
If your sprayer is a center pin
pivoting boom (the boom pivots
on a pin in the center of the
boom) then follow Section 4.6.2
to install the roll sensors.
Sometimes it best to mount the
roll sensors in an inverted
orientation (upside down). For
this type of mounting refer to
Section 4.6.3.
Figure 17: Mounting the Roll Sensor
to the Roll Sensor Mounting Bracket
Figure 18: Roll Sensor Mounting with Respect to Sprayer Orientation
* The boom frame roll
sensor does not have a
temperature probe