Moog Crossbow GNAV540 - Manual (Page 53)

GNAV540 User Manual
7430‐0808‐01 Rev. B Page 53
Chapter 7. Configuring GNAV540 with NAV‐VIEW 2.2
It is assumed the GNAV540 unit and NAV‐VIEW 2.2 have been set up. For instructions, refer to Chapter 5. Installation
Guidelines.
This section provides instructions to configure the unit via NAV‐VIEW 2.2, a GUI application. For information about
configuring the unit via programming code, refer to Programming Guidelines. Chapter 10.
NOTE: It is recommended to read and thoroughly understand the effects of altering the settings in the Advanced tab
be tion. Refer to fore making changes to the unit configura Chapter 2. GNfAV540 Functions.
• s Viewing Current Configuration
• ge 54
, page 53
Configuring the Unit, pa
The configuration tabs:
o
General, page 54
o
Advanced, page 56
o
BIT Configuration, page 56
o
Aligning the Magnetometer, page 57
NOTE: To implement a configuration, save the configuration in EEPROM and recycle the power of the GNAV540
unit. Until the power is recycled, the new configuration will not be implemented.
Viewing Current Configurations
ent settings and calibration data. The displayed information can be printed. NAV‐VIEW 2.2 enables viewing the curr
There are two methods to view current
configuration.
Met
Figure 15 Current Configuration
hod 1:
• At the main screen, select Unit
Configuration from the menu bar, then
enu. select Print from the drop m
The dialog window opens (Figure 15).