Moog Crossbow GNAV540 - Manual (Page 47)

GNAV540 User Manual
7430‐0808‐01 Rev. B Page 47
Chapter 6. Viewing and Logging Data with NAV‐VIEW 2.2
NOTE: It is assumed that GNAV540 and NAV‐VIEW 2.2 have been set up, connected and turned on. For instructions,
re 43 fer to Chapter 5. Installation Guidelines on page .
Figure 8 on page 48 shows the main page of NAV‐VIEW.
p of the page. The functions are accessed from the menu bar at the to
The graphs are displayed in the main body of the page.
• Multiple graphs are available, which can be selected for viewing, such as Angles, Angular Rate, Accel,
Velocity and GPS POS. Which graphs are available is related to the selected packet type. For details about
packet types, refer to Chapter 9. Communicating with the GNAV540 Unit.
seconds per time frame. • The time range (speed) of viewing the graphs can be selected: 2, 5, 10, 20, or 50
The bott he unit and connection to the unit om of the page indicates information about t
• connected, COM or Ethernet How the unit is
• The baud rate
•
cted and working, the following messages will be displayed: If the unit is conne
ted” “Unit Connec
Packet Rate
540 unit The serial number of the GNAV
The version of NAV‐VIEW 2.2
If the unit is not connected, the following message
ill be displayed: w
If Unit Not Connected is displayed, check the
followin
Figure 7 No Display
g:
• Are the power supply levels are correct.
• If using the serial port, verify that the correct
serial connector of the cable is being used,
and if used, the setting of the RS422 / RS 232
adaptor.
• If using the Ethernet port, verify the IP
address and the Port number are correct.