Longshine LCS-8056C2 - Manual (Page 69)

Commands for Host-Processed Modems Reference Manual
100498E Conexant 3-47
Reporting Current or Selected Values
Command: +DS44?
Response: +DS44:,,,
,,,
,,
Example: +DS44:3,0,0,2048,2048,32,32,4096,4096 For the default setting.
Reporting Supported Range of Parameter Values
Command: +DS44=?
Response: +DS44:(list of supported values),(list of supported
values),(list of supported values),(list
of supported values),(list of supported
values),(list of supported values),(list
of supported values),(list of supported
values),(list of supported values)
+DR - Data Compression Reporting
This extended-format numeric parameter controls whether or not the extended-format "+DR:
" intermediate result code is transmitted from the modem to the DTE (see Section 3.4 and
Table 3-14).
S95 bit 5 is reset to 0 for +DR=0 and is set to a 1 for +DR=1. The more recent setting of +DR
or S95 bit 5, and the W command setting, determines the actual data compression result code
reporting (see S95 Parameter and W Command).
Syntax
+DR=[]
Defined Values
decimal number corresponding to the selected option:
0 Data compression reporting disabled (no +DR result
code transmitted).
1 Data compression reporting enabled (+DR result
code transmitted). (Default.)
Reporting Current or Selected Values
Command: +DR?
Response: +DR: value>
Example: +DR: 1 For the default setting.
Reporting Supported Range of Parameter Values
Command: +DR=?
Response: +DR: ( range)
Example: +DR: (0,1)