Longshine LCS-8056C2 - Manual (Page 46)

Commands for Host-Processed Modems Reference Manual
3-24 Conexant 100498E
+ILRR - DTE-Modem Local Rate Reporting
This extended-format numeric parameter controls whether or not the extended-format
+ILRR: information text is transmitted from the modem to the DTE.
Syntax
+ILRR=
Defined Values
Decimal number corresponding to the selected option.
0 Disables reporting of local port rate (+ILRR: is not
transmitted).
1 Enables reporting of local port rate (+ILRR: is
transmitted).
Reporting Current or Selected Values
Command: +ILRR?
Response: +ILRR:
Example: +ILRR: 0 For the default setting
Reporting Supported Range of Parameter Values
Command: +ILRR=?
Response: +ILRR: ( range)
Example: +ILRR: (0,1)
Reported Rate
The reported represents the current (negotiated or renegotiated) DTE-modem rate. If
enabled, the intermediate result code is transmitted after any modulation, error control or data
compression reports are transmitted, and before any final result code (e.g., CONNECT) is
transmitted. The is applied after the final result code is transmitted.
The DTE-modem port rate will change only if neither buffered mode nor error controlled
means are enabled (+ES=x,0) and if the negotiated carrier rate (+MRR) does not match the
current DTE-modem port rate (autodetected from the previous command line).
Syntax
+ILRR: [,]