Longshine LCS-8056C2 - Manual (Page 120)

Commands for Host-Processed Modems Reference Manual
4-10 Conexant 100498E
Reporting Current or Selected Values
Command: +FTM?
Response: +FTM:
Example: +FTM: 98 For V.17 9600 bps.
Reporting Supported Range of Parameter Values
Command: +FTM=?
Response: +FTM: ( range)
Example: +FTM: 3,24,48,72,73,74,96,97,98,121,122,145,146
+FRM - Receive Facsimile
This command causes the modem to enter the receiver mode using the modulation defined
below.
Syntax
+FRM=
Defined Values
Decimal number corresponding to the selected modulation mode
and data rates shown in Table 4-2.
Reporting Current or Selected Values
Command: +FRM?
Response: +FRM:
Example: +FRM: 98 For V.17 9600 bps.
Reporting Supported Range of Parameter Values
Command: +FRM=?
Response: +FRM: ( range)
Example: +FRM: 3,24,48,72,73,74,96,97,98,121,122,145,146
Result Codes
CONNECT Reported when the selected carrier is detected.
+FCERROR Reported if another carrier is detected and FAR=0; the modem
then returns to the command state.
NO CARRIER Reported if loss-of-carrier is detected.
OK Reported if the DTE sends any character to the modem other than
XON or XOFF while operating in configured flow control from the
DTE; the modem then returns to the command state.