Longshine LCS-8056C2 - Manual (Page 102)

Commands for Host-Processed Modems Reference Manual
3-80 Conexant 100498E
S95 - Extended Result Codes Control
A bit set to a 1 in this parameter, in conjunction with the W command, will enable the
corresponding extended result code (see Section 3.4 and Table 3-14).
The +MR, +ER, and +DR settings also control S95 bits 2, 3, and 5, respectively. The more
recent settings of +MR, +ER, and +DR, or host writing of S95 bits 2, 3, and 5, along with the
W command setting, determine the corresponding actual result code reporting (see +MR,
+ER, DR, and W commands).
Default: 0
Bit 0 CONNECT result code indicates DCE speed instead of DTE speed.
Bit 1 Reserved
Bit 2 Enable +MCR: XXXX result code (XXXX = modulation) and +MRR: XXXX
result code (XXXX = rate). (See +MR.)
Bit 3 Enable +ER:XXXX result code (XXXX = protocol identifier). (See +ER.)
Bit 4 Reserved.
Bit 5 Enable +DR result code (XXXX = compression type). (See +DR.)
Bits 6-7 Reserved.
S210 - Maximum Symbol Rate
The S210 register controls maximum symbol rate selection.
Decimal number corresponding to the selected information.
0 Selects that the symbol rate will be less or equal to 2400 symbols per second.
1 Selects that the symbol rate will be less or equal to 2743 symbols per second.
2 Selects that the symbol rate will be less or equal to 2800 symbols per second.
3 Selects that the symbol rate will be less or equal to 3000 symbols per second.
4 Selects that the symbol rate will be less or equal to 3200 symbols per second.
5 Selects that the symbol rate will be less or equal to 3429 symbols per second.
Range: 0-5
Default: 5