Longshine LCS-8056C2 - Manual (Page 121)

Commands for Host-Processed Modems Reference Manual
100498E Conexant 4-11
+FTH - Transmit Data with HDLC Framing
This command causes the modem to transmit data using HDLC protocol and the modulation
defined below.
Syntax
+FTH=
Defined Values
Decimal number corresponding to the selected modulation mode
and data rates shown in Table 4-2.
Result Codes
CONNECT Reported for either of two conditions:
1. At the beginning of transmission of the training pattern for the
selected modulation.
2. If the Final Frame bit is 0.
OK Reported for either of two conditions:
1. If the Final Frame Bit is 1.
2. if the DTE sends only (a null frame) while
transmitting flags.
ERROR Reported if five seconds elapse from the time when the modem
reported the CONNECT result code without any additional data
transmitted from the DTE; the modem then turns off carrier and
returns to the command mode.
Reporting Current or Selected Values
Command: +FTH?
Response: +FTH:
Example: +FTH: 98 For V.17 9600 bps.
Reporting Supported Range of Parameter Values
Command: +FTH?
Response: +FTH?
Example: +FTH: 98 For V.17 9600 bps.