Longshine LCS-8056C2 - Manual (Page 52)

Commands for Host-Processed Modems Reference Manual
3-30 Conexant 100498E
&G - Select Guard Tone
This command is included for compatibility only and has no effect other than returning an
OK result code.
Syntax
&G[]
Defined Values
Decimal number corresponding to the selected option.
0 Included for compatibility only and has no effect
other than returning an OK result code. (Default.)
1 Included for compatibility only and has no effect
other than returning an OK result code.
2 Included for compatibility only and has no effect
other than returning an OK result code.
Result Code
OK = 0 to 2.
ERROR Otherwise.
&P - Select Pulse Dial Make/Break Ratio
This command determines the make/break ratio used during pulse dialing. It is only effective
if the appropriate bit to enable this command is set through the .INF File. If enabled, it will
override the make/break ratios in the OEM parameters in the .INF File. The default is
country-dependent.
Syntax
&P[]
Defined Values
Decimal number corresponding to the selected information.
0 Selects 39%-61% make/break ratio at 10 pulses per
second. (Default.)
1 Selects 33%-67% make/break ratio at 10 pulses per
second.
2 Selects 39%-61% make/break ratio at 20 pulses per
second.
3 Selects 33%-67% make/break ratio at 20 pulses per
second.
Result Codes
OK = 0 to 3.
ERROR Otherwise.