KGUARD Security AR 1621-2CKT001 - Manual (Page 48)

ENGLISH
Aurora Series: Configuring DVR Settings
48
DVR User’s Manual
Others
Customize the event(s) alarm settings.
Disk error: Select Enable to trigger the
alarm if the DVR has trouble to access
or detect the hard disk drive.
Disk full: Select Enable to trigger the
alarm when the hard disk drive is full.
IP address conflict: Select Enable to
trigger the alarm if the DVR has detect
another device on the same network
using the same IP address.
Trigger: Configure the actions to be
taken when the event type occurs. See
“Event Trigger Settings” on page 49 .
After all settings are complete, click Apply.
• Event Trigger Settings
In Trigger, click Settings to configure
the actions to be taken when the
event type occurs.
Send E-MAIL: Check to enable e-mail
alarm notification. If the function is
enabled, the system will send the
alarm messages to the specified
e-mail address.
Note:
Be sure to complete the E-mail and
DNS server settings before enabling
this function.
Alarm output: If an alarm device is connected, check the box to make the device sound the alarm when triggered.
Push: Check the box to enable Push Event function on Mobile/Pad when the event type occurs.
Note:
• To use Push Event function, you need to do the following:
- Enable MyKguard in DVR (see “MyKguard” on page 51 ).
- Configure the DVR network connection parameters.
- Download KView QR on your smart phone/pad. If you are using an iOS portable device, you need to enable
the Push Event function on app too.
Alarm output duration: Select the alarm sound duration of the alarm device.
Buzzer: Set the buzzer duration when the event type occurs.
P.T.Z: Check the box to activate cruise of the PTZ camera on the specified channel when the event type occurs.
Click OK to save the settings.