beautypg.com

Juniper Systems Barcode Expansion Pod User Manual

Page 9

background image

Bar Code Expansion Pod

displays on the screen approximately 1.5 sections after

each unsuccessful scan.

scanner setup

The Scanner tab is used to configure the operation of the

scan engine.

Target Time

The Target Time option allows you to set the amount of

time the target beam is on before a scan is initiated.
The Target Time box shows the time, in seconds, that the

target beam is on. The scroll buttons allow you to set the

amount of time the target beam is on before a scan is

initiated. The Target Time can vary from 0.0 to 9.9 seconds,

in 0.1 second increments.
If you set the Target Time at 2.0, that means the target

beam remains on for 2.0 seconds and then turns off as