Juniper Systems Barcode Expansion Pod - Manual (Page 7)

Bar Code Expansion Pod
Only one Field PC key is used to both target and scan
a bar code. Pressing on the scan key initiates the target
beam first. The target beam stays on for a set time ranging
from 0.0 to 9.9 seconds. You have the ability to set the
target time, see Scanner Setup. As soon as the target beam
turns off, the scan beam turns on. The scan beam remains
on until a valid scan is completed or until the maximum
scan time is reached.
Note: Holding the Scan Key down during a scan or pressing it
multiple times during the scan does not affect the scan. The key
presses are ignored.
Scan Key Selection
The Scan Key box allows the user to select which key is
pressed to initiate a scan. To select the Scan Key you want
to use, tap on the down arrow on the right side of the
Scan Key box to access a drop-down menu listing all the
available scan keys. Tap on the name of the key you want
to use for scanning.
Beep Key Selection
The Scan Key box allows the user to select which key is
pressed to initiate a scan. To select the Scan Key you want
to use, tap on the down arrow on the right side of the
Scan Key box to access a drop-down menu listing all the
available scan keys. Tap on the name of the key you want
to use for scanning.