Juniper Systems Barcode Expansion Pod - Manual (Page 19)

Bar Code Expansion Pod
1
configuration files. The defaults are the settings that come
installed on your Field PC when it is shipped.
exit setup
The Exit Setup button is available on every Bar Code Setup
tab, allowing you to close the Bar Code program at any
time. Tapping on the Exit Setup button saves all options
you set up and takes you back to the Bar Code Reader
screen.
Tap on Begin Scan to start the bar code scanning program.
Tapping on the Exit or X button, in the top right corner,
exits out of the Bar Code Setup program.
Begin scanning
The bar code scanning program allows bar code data to
be directly entered into an application program. The bar
code data is entered into the data collection program as
electronic data, as if it were typed on the keyboard.