Juniper Systems Barcode Expansion Pod - Manual (Page 10)

10
Bar Code Expansion Pod
the scan beam turns on. The scanner takes approximately
.5 seconds to focus the target beam. Because of this, it is
recommended that the minimum target time be set to 0.5
or longer than the desired target time.
Scan Time
The Scan Time option allows you to set up the amount
of time the scan beam remains on to perform a bar code
scan. The Scan Time window shows the time, in seconds,
that the scan beams is on. The scroll buttons allow the
user to set the amount of time the scan beam is on. The
Scan Time can vary from 0.0 to 9.9 seconds, in the 0.1
seconds increments.
A scan terminates as soon as it successfully reads a bar
code or when the scan time has reached the maximum
scan time specified in Scan Time window.
Scan Button
The Scan button allows you to test the functionality of
the scanner within the setup program. Pressing the Scan
button turns the target beam on for the Target Time and
then performs a scan.
Scan Data
The Scan Data field is used to display the results of scans
initiated by the Scan button.
Scan Angle
The bar code scanner is capable of using two different
scan angles. The Scan Angle determines the width of the
scan beam.