Juniper Systems Barcode Expansion Pod - Manual (Page 8)

Bar Code Expansion Pod
Beep on Good Read
The bar code scanner program provides audio feedback
to notify you on a successful scan. To activate the audio
feedback, tap in the Good Read box in the Beep On: section
so a checkmark appears. A single beep sounds at the
completion of a successful scan.
Beep on No Read
The bar code scanner program provides audio feedback
to notify you about an unsuccessful scan. To activate the
audio feedback, tap in the No Read box in the Beep On:
section so a checkmark appears. Two beeps sound when a
scan is unsuccessful.
Good Read Message
The bar code scanner program provides visual feedback
when a scan is successful. To activate this visual feedback,
tap in the Good Read in the Visual On: section so a checkmark
appears. A Scan OK! pop-up message displays on the screen
approximately 1.5 seconds after each successful scan.
No Read Message
The bar code scanner program provides visual feedback
when a scan is unsuccessful. To activate this visual
feedback, tap in the No Read in the Visual On: section so
a checkmark appears. A Scan Failed! pop-up message