Juniper Systems Barcode Expansion Pod - Manual (Page 20)

0
Bar Code Expansion Pod
When a scan is initiated, the bar code scanning program
transfers the data into the data collection program
you have open. The scanned data enters at the cursor’s
location in the data collection program. After each scan,
place the cursor at the next location for scanned data
entry.
To start the bar code scanning program and begin
scanning, complete the following steps:
1.
Tap on the Bar Code Reader icon on your Field PC’s
desktop and set up your scanner as outlined in
the Setup Bar Code section. If this step is already
completed, proceed to step 2.
2.
Tap on Begin Scan button on the Bar Code Reader
screen.
3.
Open the data collection program you want to receive
and store the scanned bar code data. Example: If you
want your bar code scans placed in a Mobile Excel
file, open your Field PC’s Mobile Excel program.
Note: Keep the data collection program in the foreground of
your Field PC when scanning; otherwise the scanned data
is not entered.
4.
Position the cursor in the data collection program in
the cell you want the scanned data to enter.
5.
Press your specified scan button to target, and then
scan your bar code.