Juniper Systems Trimble Lassen GPS Expansion Pod - Manual (Page 9)

GPS Expansion Pod
After the settings have been selected, tap on the Apply
Settings button to save the new settings. Tap on the Get
Settings button to bring up the GPS pod current settings to
double check them.
Reviewing and Editing the Receiver Parameters
Once you determine which data format you are going to
use, follow these steps to review and edit the parameters
as needed:
1.
Click on the Get Settings button to reset the
parameters to their default setting.
2.
Change the parameters, if necessary, by clicking on
the down arrow on the right of the Baud, Parity, Stop
Bits, and/or GPS Data Format box to bring up a list of
setting options, and click on the setting you want.
3.
Click on the Apply Settings button.
4.
Click on the Ok in the top right corner to minimize
the program.
5.
To completely close the program go to Start > Settings
> System tab > Task Manager. Click End Task.