Gps pod setup program, Specifying gps receiver port settings – Juniper Systems Trimble Lassen GPS Expansion Pod User Manual
Page 4
Field PC GPS Expansion Pod
7.
Attach the antenna on the antenna bracket.
8.
Remove the protective cap from the connector
labeled GPS ANT (save the cap for future use). Screw
the antenna cable into the Expansion Pod.
You have completed the steps to attach the antenna
bracket to the Field PC GPS Expansion Pod.
GPS Pod Setup Program
The GPS Pod Setup program is factory installed on
your Field PC. The program allows you to configure the
parameters of the internal GPS receiver to accommodate
the various GIS/GPS programs that run on the Field PC.
The Field PC communicates with the internal GPS
receiver. The GPS Pod Setup program allows you to
change the serial port settings being used (i.e. baud rate,
parity, stop bits), and to select between TSIP and NMEA
data output formats.
Specifying GPS Receiver Port Settings
To set up the parameters on the GPS receiver Port Settings
complete the following steps:
- Allegro 2 Quick Start (1 page)
- Allegro 2 User Guide (119 pages)
- I/O module Allegro 2 (1 page)
- A2 Ethernet Dock (2 pages)
- A2 Ethernet Multi Dock (2 pages)
- Allegro MX User Guide (96 pages)
- Allegro MX Quick Start (1 page)
- AMXU GPS Expansion Pod (12 pages)
- Allegro Top Mounting Bracket (4 pages)
- Holux M-215+ for Allegro (2 pages)
- Holux GR-213 for Allegro (2 pages)
- Barcode Expansion Pod (22 pages)
- USB/Power Dock Pogo Pin (1 page)
- 12449 Alkaline (1 page)
- Allegro DAQ (28 pages)
- Allegro Desiccant Kit (5 pages)
- Allegro CX and CE Bluetooth CF Card (32 pages)
- Allegro CX Manual (304 pages)
- Allegro CX Quick Start (6 pages)
- Allegro DOS Manual (166 pages)
- Allegro DOS Manual (274 pages)
- Allegro DOS Quick Start (4 pages)
- Allegro DOS Quick Start (2 pages)
- Allegro CE Manual (292 pages)
- Allegro CE Quick Start (2 pages)
- Archer 2 User Guide (1 page)
- Archer 2 User Guide (133 pages)
- Archer 2 Quick Start (1 page)
- I/O module Archer 2 (1 page)
- Bumper kit Archer 2 (1 page)
- Handstrap kit Archer 2 (1 page)
- ikeGPS (16 pages)
- Archer Quick Start (2 pages)
- Archer Reference Guide (153 pages)
- Archer User Manual (384 pages)
- XF101 (2 pages)
- Travel Charger for the Ultra-Rugged Field PC (8 pages)
- Field PC Cap Replacement (1 page)
- Replacing the Communications Module on the Field PC (2 pages)
- ltra-Rugged Field PC Extended Caps (16 pages)
- Socket Bluetooth Card (6 pages)
- Mesa User Guide (112 pages)
- Mesa Addendum (1 page)
- Mesa Quick Start (2 pages)