Juniper Systems Trimble Lassen GPS Expansion Pod - Manual (Page 3)

GPS Expansion Pod
Attaching the Antenna Bracket
Before you can use the GPS Expansion Pod, you must attach
the antenna bracket using the GPS Pod Setup Program. To
do this, complete the following steps:
1.
Remove the antenna bracket assembly from the
bag and loosen the two thumbscrews located at the
bottom of the mount.
2.
Remove the stylus from the Field PC.
3.
Insert the antenna bracket mount by placing the
attached stylus into the top of the Field PC. Slide the
metal cover into the stylus slot so that the stylus fits
into place.
4.
Make sure the rubber stylus holders are not pressed
inward or they may pop the antenna bracket out of
the stylus holder. Remove the Field PC’s connector
protector to make this step easier.
5.
Place the two knobs on the end of the antenna
bracket into the screw holes located above the
communication ports of the Field PC.
6.
Tighten the thumbscrews on the antenna bracket so
that the bracket is securely fastened into place. You
want the thumbscrews to be snug, but do not over-
tighten them.