Philips STU 901/25R - Manual (Page 27)

FAULT
Receiver does not operate
If the Receiver does not give the desired result when used
if you have any of the faults shown, take the required action and,
if this does not achieve the required result.
CAUSE AND ACTION
check the power connection
check the satellite dish antenna and/or
AN connections
check the position of the ANTENNA CONTROL SWITCH (28).
verify that the batteries of the remote control are not
exhausted.
consult your dealer.
Cannot select TV programmes when Receiver is switched
on.
With some TV sets it may be impossible to select a normal TV
programme while the satellite Receiver is switched on. This may
be the case if, for example, you have your satellite Receiver
connected to your TV by means of an
AN connector cable and
you want to make a recording of a satellite programme while
watching a normal TV programme.
If this occurs, you should press the TV/SAT button (3) on your
remote control once. Now you can select and watch TV
programmes.
If you wish to return to the satellite programmes, press the same
TV/SAT button (3) again.
If you have no problem changing TV channels while your satellite
Receiver is switched on, you do not need to use the TV/SAT
button.
Poor reception
If you have followed carefully the instructions in Section 2 “HOW
TO CONNECT YOUR RECEIVER”, you should get good
pictures and sound.
If not, first check the section 'Adjust the Polarizer' carefully.
- Check dish position
If this does not improve things, then the problem may be due to
objects such as buildings or trees between your dish and the
satellite. Ask your dealer for advice.
Scrolling picture
The picture is not stable, scrolls or disappears and appears all
the time. Do the following:
- press the MENU button (8) on the remote control
- press 7 to select INSTALLATION
- press 2 to select SATELLITE PROGRAMMES
- press 1 to select CHANNEL SELECTION
The menu will disappear. Press - and + once and see if the
channel comes in. If not, you may be tuned to a programme with
conditional access for which you have no authorisation.
- press MENU to go back to the menu
- press 7 to STORE your settings
- press MENU OFF to exit
Repeat this procedure for other programmes if necessary.
Note: If with any of these above mentioned actions you do not achieve the required
result, you should consult your dealer.
(GB) 23