Philips VKR 9010 - Manual (Page 15)

Setting of the date and time
Push the DATE/TIME selector button.
The indication shown below will appear in the
electronic viewfinder (EVF).
0:12
1. 1.1990
• If no battery is inserted, the indication
“BACKUP” will light up.
When the SHIFT button is kept pressed for more
than about 2 seconds, the “Year” portion will
start to flash. Then, at every press of the SHIFT
button, the items to be set will flash in the
following sequence.
-> Year -> Month
-*
Date -» Hour -> Minute -+ Year ->
1990 -» 1991 ....... ....... 2089 -> 1990 -> ...
^ - * 2 - ^ ................ ................12 1 -♦ ...
1 -> 2 .................... ................31 ^ 1 -»• ...
0 -> 1 .................... ................23 -> 0 ^ ...
00 ^ 01 ^ .............. ............. 59 -»■ 00 ...
When the SET button is pushed, the flashing
portion displayed will be changed in the
following sequence.
YEAR
MONTH
DATE
HOUR
MINUTE
• Repeat procedures 2 and 3 until all items have
been set.
• Once the time and date are set, press the SHIFT
button in response to a precise time signal so that
the clock may begin to function.
Recording the date/time indications
When the DATE/TIME selector is pushed repeatedly,
the indications will change in the following sequence.
No indication Date and time Date
13