Power supply system, Inserting the battery pack (sbc5217), Removing the battery pack (sbc5217) – Philips VKR 9010 User Manual

Page 12: Car battery cord (sbc5422), Power suppiy system

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Power supply system

Inserting the battery pack (SBC5217)

^ Align the grooves of the left side of the battery

pack and the Camcorder.

2 Push the battery pack until it iocks v/ith a ciick.

Removing the battery pack (SBC5217)

^ Slide the battery eject lever to remove the

battery.

2 Pull out the battery pack.

AC adaptor (SBC5420)

Connect the DC input cable from the DC output

socket on the AC adaptor to the DC input socket
on the Camcorder.

2 Connect to the mains.

Note:

When a battery pack is attached on the AC adaptor,

the Camcorder cannot be supplied with power.

Car battery cord (SBC5422)

■| start the engine and insert the car battery cord

into the cigarette lighter socket.

2 Connect the other end to the DC input socket on

the Camcorder.

Notes:

• The car battery cord can only be used with 12V DC

negative-grounded vehicles.

• Do not start the car engine whiie the Camcorder is