Philips CCB 132AT - Manual (Page 8)

8 Turning On the TYIVCR
Before you turn on theTV/VCR., make sure batteries are in the
remote control and theTV/VCR is hooked up correctly.
The instructions on this page work only when you turn on the
TV/VCR for the first time.
I
Press the POWER button. The TV/VCR will come on and the
screen shown below will appear.
' select language
> ENGLISH ON
ESPAÑOL
SELECT
AT
OP
PRESS MENU TO CONTINUE
Press the PLAY/ a button or the STOP/v button to select
English or Spanish on-screen displays and menus.
3
Press the MENU button. The screen shown below will appear
' COMsECTAfTTB^ OR CABl£
TO TVCR
THEN PRESS»
TO END PRESS EXIT
4
5
Use the CH(annel) / button or the Number buttons
on the remote control to select a TV/VCR channel. Use
the VOL(ume) / button to adjust the sound.
Press the F.FWD/^- button to begin automatic channel
setup.
The TV/VCR will memorize all available channels. When
channels are set, CHANNELS ARE SET will appear on the screen
briefly.Then theTV/VCR will go to the lowest channel pro­
grammed.
(If you try to set up channels when there is no antenna or cable
connected to the TV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ... message will appear on the
screen. Connect an antenna or cable to the ANT(enna) jack on the
TV/VCR, then press the F.FWD/^ button again.You may need to
follow the steps on page 10 instead.)
4
If you do not see ony on-screen dis­
plays when you turn on the TVIVCR,
check your hookups, then try again.
If you still do not see any on-screen
displays, follow the steps on pages
nine-10 to select a language and
set up channels.
To skip step 2, press the MENU
button. All on-screen displays will be
in English. To skip step 4, press the
STATUS/EXIT button. Channels will
not be set up, and CHANNELS TJOT
SET will appear on the screen
briefly.
You cannot set up channels if you
are using a Cable Box.
Line Input mode will always be
stored in the TVIVCR’s memory as
channel 00. When you select chan­
nel 00, AN IN will appear on the
screen briefly. Press the CH(annel)
/ button or the Number but­
tons to select another channel.