Rod antenna, Hooking, Thev/ncr – Philips CCB 132AT User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6
Hooking
up
theV/NCR
[
Hook up yourTV/VCR using one of the connections shown.
A.
Hooking Up YourTV/VCR
With a Cable Signal or
Outdoor Antenna
Connect a Cable signal
or an antenna to the
ANT(enna) Jack.
CCBI30
B.
Hooking Up YourTV/VCR
With a Cable Box
To view any channel, set the TV/VCR
to the Cable Box output channel
(channel 03 or 04),Then, select chan
nels at the Cable Box.
Connect the Cable signal to
the IN jack on the Cable Box._
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT Jack
on the Cable Box and to the
ANT(enna) jack on theTV/VCR.
CCBI30
RF coaxial cable
(not supplied)
c.
Hooking Up YourTV/VCR
With an Indoor Antenna
To install a rod antenna (not sup
plied), push the stem of the antenna
into the antenna hole on the top of
theTV/VCR. Connect the antenna
wire to the ANT(enna) Jack on the
back of theTV/VCR as shown.
Extend the antenna and adjust its
length, direction, and angle for the
clearest picture.
Rod Antenna
(not supplied)
CCBI30