IC Realtime 2 Megapixel Full HD 20x Optical Network PTZ Camera IP66 300 ft IR (ICIP2001HDIR) User Manual

Page 29

IP Version

It is to select IP version. IPV4 or IPV6.

You can access the IP address of these two versions.
z Please note system needs to check the validity of all

IPv6 addresses. The IP address and the default gatewa
shall be in the same IP section. That is to say, the
specified length of the subnet prefix shall have the sam
string.

z When PPPoE function is enabled, the IP/subnet

mask/default gateway is read-only. You can not set or
restore default setup.

IP Address

Please use the keyboard to input the corresponding number to
modify the IP address and then set the corresponding subnet
mask and the default gateway.

Default Gateway It is the similar gateway of the IPv4. It shall not be left in blank.

Preferred DNS

DNS IP address. It is the similar DNS of the IPv4. It shall not be
left in blank.

Alternate DNS

Alternate DNS IP address. It is the similar DNS of the IPv4. It
shall not be left in blank.

Enable
ARP/Ping set
device IP
address service.

You can use ARP/Ping command to modify or set the device IP
address if you know the device MAC address.

Before the operation, please make sure the speed dome and
the PC in the same LAN. This function is on by default.

You can refer to the steps listed below.

Step 1: Get an IP address. Set the speed dome and the PC in
the same LAN.

Step 2: Get the physical address from the label of the speed
dome.

Step 3: Go to the Run interface and then input the following
commands.

arp –s

ping –l 480 –t

Such as：arp ‐s 192.168.0.125 11‐40‐8c‐18‐10‐11

ping ‐l 480 ‐t 192.168.0.125

Step 4: Reboot the device.

Step 5: You can see the setup is OK if you can see there are
output information such as “Reply from 192.168.0.125 …” from
the command output lines. Now you can close the command
line.

Step 6: Open the browse and then input http://.
Click the Enter button, you can access now.