IC Realtime 2 Megapixel Full HD 20x Optical Network PTZ Camera IP66 300 ft IR (ICIP2001HDIR) - Manual (Page 12)

8
Click PTZ set button, the interface is shown as in Figure 1-12.Here you can select scan, preset, tour
pattern, assistant function and etc.
Figure 1-12
Please refer to the following sheet for PTZ setup information.
Parameter Function
Scan
z
Select Scan from the dropdown list, click Set button and then
control the PTZ to set the scan left limit and right limit. Start
button, you can begin scan operation. Default SN is 1.
Preset
z Select Preset from the dropdown list, input the preset value and
then click Add button, now system save current position as one
preset. Click View button, the camera turns to the corresponding
position of the preset.
Tour
z Select Tour from the dropdown list and then input tour value.
Click Add or Delete button to add/remove one preset from the
tour. Click Start button, you can begin tour.
Pattern
z You can select Pattern from the dropdown list and then click
Add button, now you can operate PTZ to realize zoom, focus,
iris, direction operation and etc. Click Stop button to stop
memory pattern process. Click Start button to begin PTZ
movement.
Assistant
z Input assistant value and click AUX on button to enable
corresponding assistant value. Click AUX off button to disable
assistant function.