Carrier V2203-DI (26--00128) - Manual (Page 62)

4--1 62--11362
SECTION 4
COOLING SYSTEM
4.1 CHECKING AND ADJUSTING
WARNING
Beware of moving V--belt and belt driven
components
4.1.1 Notched V--Belt Service
NOTE
A frayed, cracked or worn V--belt must be re-
placed. After installing a new belt, it is advisable
to check the adjustment after running the unit
for three or four hours. This will allow for the ini-
tial stretch, which is common on new belts.
Once this initial stretch has taken place, the belt
should be checked at regular intervals.
To replace or adjust the notched V--belt, do the
following:
a. Replacing the V--Belt
1. Loosen the idler pivot bolt.
2. Replace the belt and adjust tension in accordance
with the following steps.
b. Adjusting Tension
1. Measure the deflection (A), by depressing the belt
halfway between the fan drive pulley and alternator
pulley at the specified force (Refer to1.7.3).
2. Use hand force only on the idler pulley to tighten belt.
Do not use a pry bar or excessive force as it may
cause damage to the engine.
Use of a belt tension gauge (Carrier Part #
07--00203--00) or a belt tension tester (Carrier Part #
07--00253--00) is advised.
3. When belt is at correct tension, tighten pivot bolt.
4.1.1a Poly V--Belt Service
a. Replacing the Poly--V--Belt
1. Apply the proper size socket to the crank pulley nut,
then slowly rotate the crank. At the same time, use a
flat, blunt object to guide the belt off the crank pulley
towards radiator. Be careful not to damage grooves
on the pulley.
2. Replace the Poly--V--Belt by positioning the belt on
the water pump pulley, and while rotating the engine
(as in step 1), use a flat, blunt object to guide the belt
onto the crank pulley. Be careful not to damage
grooves on the pulley or belt.
4.1.2 Fan Belt Damage and Wear
1. Check the fan belt for damage.
2. If the belt is damage in any way, replace it.
(A)
(B)
A. Good B. Bad
3. Check if the belt is worn and sunk in the pulley groove.
4. If the fan belt is worn and deeply sunk in the pulley
groove, replace it.
A. Good B. Bad
4.1.3 Checking Coolant Level
WARNING
When removing the radiator cap, wait at
least ten minutes after the engine has
stopped and cooled down. Otherwise, hot
water may discharge from the radiator,
scalding anyone nearby.
1. Remove the radiator cap and check to see that the
coolant level is just below the port.
With the recovery tank: Check to see that the coolant
level lies between FULL and LOW.