Carrier V2203-DI (26--00128) - Manual (Page 58)

2--32 62--11362
2.3.4 Crankshaft (Continued)
1. Stopper
2. Sleeve Guide
3. Crankshaft Sleeve
4. Auxiliary Socket For
Pushing
5. Crankshaft
2.3.4.g Replacing Crankshaft Sleeve
1. Remove the crankshaft sleeve (3) using a special--
use puller set.
2. Set the sleeve guide (2) to the crankshaft (5).
3. Set the stopper (1) to the crankshaft (5) as shown in
the figure.
4. Heat the new sleeve to a temperature between 150 to
200 ° C (302 to 392 ° F), and fix the sleeve on the crank-
shaft (5) as shown in the figure.
5. Press fit the sleeve using the auxiliary socket for
pushing (4).
NOTE
Install the sleeve with the largest chamfered
surface facing outward.