Heli-Max HMXE0828 - Manual (Page 5)

5
GENERAL HELICOPTER SPECIFICATIONS
Management: Collective Pitch, 120 degree CCPM, TAGs control
Motors: Brushless main motor, brushed tail motor
Empty
Weight: 47.8g (1.69oz)
Weight RTF: 60.1g (2.12oz)
Blade Length: 105mm (4.13”)
Tail Rotor Diameter: 38mm (1.5”)
Overall Length: 312mm (12.3”)
Height: 81mm (3.18”)
Width: 52mm (2.04”)
Gear Ratio: 8:1
MOTOR SPECIFICATIONS (1412 Brushless Motor)
Diameter: 14.5mm
Length: 13.6mm
Weight: 6.9g
Voltage: 3.7v
No load Current: .7 amp
KV: 14,750
CONTROLLER SPECIFICATIONS
Max current (5min): 10 amp
Thermal protection: 90˚C~120˚C
Slow Start Function: Yes
Soft
cutoff: Yes
®
OPERATIONAL WARNINGS OPERATIONAL WARNINGS
● Please allow a 10 minute cool down period after each flight so the
motor controller and motor can cool down. Failure to do so may cause
loss of control due to the controller overheating and shutting down.
● Inspect the main rotor blades and blade screws before each flight for nicks
or loose components. If any damage is found or if the blades have been
damaged, replace the blades before flying the model again.
● The motor controller has a soft cut function that will reduce the power output
to protect the flight battery. Toward the end of a flight you will notice a slight
power reduction. Land the model immediately. The flight time of the AXE100
SS/SSL can be as long as 6 minutes (Standard Hover) but this will vary
depending on your flying style.
● After a crash you must inspect all plastic parts on the helicopter for damage
before attempting to fly the model again.
● Always unplug your battery from the helicopter after use.