Heli-Max HMXE0828 - Manual (Page 20)

20
REPLACING THE FORWARD SERVO
Remove the canopy. Remove the link from the swashplate. Unscrew the two
screws from each side of the servo mount. Snake the wire out of the loom and
then unplug the servo.
REMOVING THE TAIL BOOM
Remove the canopy. Unplug the connector leading to the tail motor. Snake the
wires away from the bundle. Grasp the tail boom and pull it away from the main
frame. If you find the boom hard to remove, use a drop of CA debonder on the
parts and allow that to work into the joint before you try to remove it again.