Heli-Max HMXE0828 - Manual (Page 15)

15
®
MAINTENANCE MAINTENANCE
TOOLS NEEDED
● Small screwdriver (provided)
● Soldering iron
We will describe a few simple repairs
that you can do to your helicopter. We
will list them as “removing” with the
understanding that to reassemble one
just follows each step again from the
bottom up. NOTE: It’s a good idea to
keep a magnet handy to help secure
the small screws. You can also use this
magnet to “magnetize” your screwdriver; just rub the end of the screwdriver on
the magnet for a few seconds. This works nicely to keep the screws in place on
the tip of the screwdriver. TIP: we use a small piece of white paper over the
magnet to help see the screws.
REMOVING THE CANOPY
Carefully pull the back edges of the canopy outward, sliding the rubber grommets
off the pegs. Then side the canopy forward.