Great Planes Corsair 40 Kit - GPMA0177 - Manual (Page 19)

D 12. Use the template on the wing plan to make two
bellcrank sheets from the 3/32" scrap balsa LE sheeting.
Glue the bellcrank sheet to the LE sheeting and ribs T-1
and T-2. Finish covering rib T-1 with a 1/2" cap strip and T-2
with a 1/4" cap strip.
D 13. Inspect all the glue joints in the wing and apply CA
where necessary. Using 220-grit sandpaper, blend the LE
into the LE sheeting.
D 14. Use 6-minute epoxy to glue the wing dowel in
perpendicular to the LE.
D 15. Drill two 1/4" holes through the wing center TE using
the holes in the wing plate for the locations.
Well, that completes the wing construction for now, so clean
up your work bench, grab a cup of coffee, and let's start
building the fuse.
Building Notes:
19