beautypg.com

Standard communications contract warranty, Statutory warranties, Additional warranties – GME G142CFD User Manual

Page 43: Other limitations, Gme after sales service

background image

STANDARD COMMUNICATIONS CONTRACT WARRANTY

1. Statutory Warranties

1.1 The Trade Practices Act Part V, Division 2A and other legislation

imply conditions, warranties and other obligations on us to

consumers that cannot be excluded, restricted or modified. Those

provisions apply to the extent required by law.

1.2 We exclude all other conditions, warranties and obligations which

would otherwise be implied concerning the activities covered by

this agreement.
1.3

We limit our liability where we are allowed to do so.
Examples of where we are allowed to limit liability are -
(a) you acquire goods from us for re-supply;

(b) the goods or services we supply are not of a

kind ordinarily acquired for personal, domestic or

household use or consumption.

1.4 Where we are allowed to limit our liability, to the extent permitted

by law, our sole liability for breach of a condition, warranty or

other obligation implied by law is limited -
(a) in the case of goods we supply, to any one of the following as

we decide -

(i) the replacement of the goods or the supply of equivalent

goods;

(ii) the repair of the goods;

(iii) the payment of the cost of repairing the goods or of

acquiring equivalent goods;

(iv) the payment of the cost of having the goods

repaired; or

(b) in the case of services we supply, to any one of the following

as we decide -

(i) the supplying of the services again;

(ii) the payment of the cost of having the services

supplied again.

2. Additional Warranties

2.1 The warranties in this clause are in addition to the statutory

warranties referred to in the previous clause.

2.2 We warrant our goods to be free from defects in materials and

workmanship for two years from the date of original sale (or

another period we agree to in writing). During this period and

as our sole liability to you under this warranty, we agree to, at

our option, either repair or replace goods which we are satisfied

are defective. We warrant replacement parts for the remainder

of the period of warranty for the goods into which they are
incorporated.

2.3 We warrant our other repairs to be free from defects in materials

and workmanship for three months from the date of the original

repair. During this period and as our sole liability to you for the

repair, we agree to repair or replace (at our option) repaired

goods which we are satisfied are defective.

2.4 We warrant that we will perform services with reasonable care

and skill and agree to investigate any complaint made in good

faith that we have performed services unsatisfactorily. If we are

satisfied that the complaint is justified, and as our sole liability to

you under this warranty, we agree to supply those services again

at no extra charge to you.

2.5 If you want warranty service under this clause you must give us an

original or copy of the sales invoice from the transaction or some

other evidence showing details of

the transaction.

3. Other Limitations

3.1 You may not rely on any representation, warranty or other

provision by or for us which is not covered by clause [ 1 ] or

repeated in this agreement in clear terms.

3.2 We are not liable (nor are our employees, contractors and agents)

for any damage, economic loss or loss of profits whether direct,

indirect, general, special or consequential -
(a) arising out of any breach of any implied or express term,

condition or warranty; or

(b) suffered as a result of our negligence (or that of our

employees, contractors or agents) apart from liability as set
out in the previous two clauses.

3.3 The liability of a party under this agreement (whether arising

in contract, tort or by statute) is to be reduced by the same

proportion as represents the proportion of the loss or damage

caused or contributed to by the other party, its contractors or

agents.

GME After Sales Service

Your GME G•Combo/G•Plot is especially designed for the environment

encountered in marine applications. The use of all solid state circuitry,

careful design and rigorous testing, result in high reliability. Should

failure occur however, GME maintain a fully equipped service facility

and spare parts stock to meet the customer’s requirements long after

expiry of the warranty period.

Drawing Number: 45240-2 Part Number: 310501

This manual is related to the following products: