GME G142CFD - Manual (Page 38)

G - C O M B O I N S T R U C T I O N M A N UA L PA G E 3 9
4-8 Alarms
Press and hold MENU then Alarms:
A warning message with beep sound is displayed when an
alarm condition is met by user setting. Press ESC to clear the
alarm. However, the alarm will be displayed again when the
alarm condition reoccurs. The unit provides alarms for various
functions.
4-8-1 Fish
Triggers an alarm when echo from the transducer is matched
to a preprogrammed fish profile.
4-8-2 Deep
Triggers an alarm when the depth value received from the
transducer is deeper than a set value.
4-8-3 Shallow
Triggers an alarm when the depth value received from the
transducer is shallower than a set value.
4-8-4 Temperature
Triggers an alarm when the reported temperature from the
transducer is the same as a set value.
4-8-5 Temperature rate
Trigger an alarm when the rate of temperature change from
the transducer is same as a set value.
4-8-6 Low battery
Triggers an alarm when battery voltage is lower than a set
value.
4-8-7 Navigation alarms
Arrival radius: Triggers an alarm when your boat is
approaching the destination to a set value.
Anchor alarm: Trigger an alarm when your boat moves more
than a set value.
XTE: Triggers an alarm when your boat moves off the current
CDI scale.
Danger: Triggers an alarm when your boat is getting close to
a dangerous point.
4-8-8 AIS
See the Alarm option of 4-7 (AIS Settings).
4-8-9 DGPS
Triggers an alarm when DGPS signal is not received.
4-8-10 Restore default
Returns every alarm setting to default.
4-9 Others
Press and hold MENU then Others:
4-9-1 Simulate
Simulate : Turn the simulate mode on or off.
Mode : See 2-4 Simulate Mode.
Speed : The simulated boat speed to use.
Course : The simulated course over ground.
Route : The route to follow.
4-9-2 Waypoint
Select a way to display waypoints.
4-9-3 GPS
See 4-4 GPS Settings.