Philips VR727 - Manual (Page 27)

Programming on the remote control
You can enter and store the data for one recording in the
remote control.
The remote control display shows you all the programming
steps. Use the digit buttons or button liii or to
enter the data.
With the last press of the button you transmit the pro­
grammed data to the video recorder. The data will be
stored in the next free TIMER block of the video recorder.
Make sure that you have not inserted a cassette with erase
protection.
O Press button i::iTiMER„RC JijEj.
The remote control display will show, e.g.:
TIMER VCR]
n I
LI I
*V.\\ I /y
= DATE i PROG
The data last entered will appear.
Now enter the date on which the recording is to be made.
If the dispjay also shows the indicator 'D' or 'W', press but­
ton i..i..SELECT,.i..i one or more times until only 'DATE' is
shown.
O
Press button L.J.TIMER..R.C The display will show,
e.g.:
TIMER VCR]
n I
LI I
DATE = PROG s
Now enter the programme number of the TV channel from
which you want to record.
O
Press button Si5lf.lMER__8£ display wil
show, e.g.:
TIMER
on.nn
L U*ULI
\\ \ ! / *
-START-
YCRl
orunn
L URLILI
END
Now enter the start time of the recording.
O
Press button The display will show,
e.g.:
TIMER
on. 10
LLI* IJ
START
w\ I //,
VCRIlO)]) z
// /1
i/n.nn
L U’UU
■S. \\ I />» X'
H TND ^
Now enter the end time of the recording.
O
Transmit the data to the video recorder. To do this,
point the rempte cpntrpi at the video recorder and press
button Sii.TJMER,..BP. .0J?y.
The programmed data is now sent to the video recorder.
If the video recorder has correctly received the data, the
video recorder display shows, e.g.:
1 OOO Ti
TIMER
I 1'^ t—l l±l ‘
Programming is now complete. The data has been stored in
a TIMER block (e.g. 'TIMER 1').
0М 25