Futaba 4PKS 2.4GHz - Manual (Page 80)

5 : 5 7 : 3
Warning display
80
Fu
n
c
tio
n
(Opening Screen)
MENU 1
Press t he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t he button
* W h e n t h e d ire c t c all but to n
is set, the setup screen is also
called by the following method:
s3ELECT
button
* b l i n k s a t t h e c u r r e n t
setup item.
-The neutral brake function is a function switch function (page 88), and setting the neu-
tral brake function ON/OFF switch is necessary.
Neutral brake, which applies the brakes at the throttle trigger neutral position, can
be set. However, for Futaba speed controller (ESC) MC950CR, MC851C, MC602C,
MC402CR, etc, considering safety, when the neutral position is not confirmed, the set
will not enter the operation mode to prevent the motor from rotating instantly when the
power is turned on. When using the MC950CR, MC851C, MC602C, MC402CR, etc.,
check that the ESC is in the neutral position and set the neutral brake function switch to
ON after the set enters the operation mode.
An LED blinks while the neutral brake function is active (when LED is enabled). In
addition,
appears on the initial screen and menu screen.
Operation display
If the power switch is tur ned on
while the neutral brake switch is
on, an audible alarm will be heard.
Immediately set the neutral brake
switch to OFF.
F50/B50 F70/B30
Throttle Mode "THMOD"
-This function allows selection of the forward side and brake (reverse) side operation ra-
tio from 70:30 or 50:50 by changing the neutral position of the throttle servo.
When "CUT OFF", which provides trigger brake side operation in the boat mode
(page 78), is set, the neutral brake function cannot be used because brake operation is
stopped. In addition, the neutral position does not change even though the throttle mode
is changed.
When "TRG-BRK" was set to "CUT OFF" by boat mode function
Setup items
NT-BRK : Neutral Brake
MODE : Foward side / Brake side
Forward side Brake side
Throttle Mode "THMOD" (Throttle system)
Forward side Brake side