Futaba 4PKS 2.4GHz - Manual (Page 55)

W h e n R X T Y P E i s s e t t o
"FASST-C1", the BATT-F/S func-
t i o n a u t o m a t i c a l l y b e c o m e s
"ACT"(active).
BATT-F/S Voltage
3.5v, 3.8v, 4.4v, 4.75v, 5.5v
Initial value 3.8v
5.5v : Only R614FF
Battery fail safe function
OFF, ON
Initial value: OFF
55
Fu
n
c
tio
n
When the receiver power supply of an electric car uses a common power supply from an ESC, we recommend that this function be
set to OFF because the voltage supplied to the receiver may drop momentarily and the battery fail safe function may be activated.
Fail Safe/Battery Fail Safe Function "F/S"
(Preparation)
- Select the channel to be set by (JOG) button operation.
1
(Mode selection)
Select the mode by (+) or (-) button.
(Each channel can be individually
set.)
2
When ending hold or off mode setting, return to the initial
screen by pressing the (END) button twice (for function menu
screen, press the (END) button once). When setting fail safe,
set the servo position by the following method.
Fail safe mode selection
(Preparation)
- Select the setting item by (JOG) button operation. For BATT-F/
S function ON/OF, select "OFF" or "ACT" of "BATT-F/S(TH)".
For voltage setting, select RX**v (3.5v, 3.8v, 4.4v, 4.75v, 5.5v).
1
(Battery fail safe function ACT/OFF)
BATT-F/S function ACT/OFF and
voltage setting which activates the
BATT-F/S function can be switched
by (+) or (-) button.
2
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
Battery fail safe function ON/OFF & BATT-F/S voltage setting
1
(Servo position setup)
When the fail safe function operates, the steering wheel,
the throttle trigger or 3rd channel dial remains in the desired
operation position. When the (+) and (-) buttons are pressed
simultaneously for about 1 second, the servo position is dis-
played and you can confirm that the function was set.
When you want to release the setting, press the (+) or (-)
button for 1 second. "HOLD" is displayed.
(Each channel can be set similarly.)
2
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
Fail safe function setup
Setup item selection
- Select by (JOG) button up or
down operation.
F/S position setup button
- The (+) and (-) buttons are
pressed simultaneously for
about 1 second.
F/S mode selection
- Select with the (+) or (-) but-
tons.
F/S mode
OFF, HOLD, F/S