Futaba 4PKS 2.4GHz - Manual (Page 29)

Antenna #OAXIAL
Tactile switch/LED
29
B
e
for
e
Using
Receiver Terminology
How to link the transmitter and the receiver
Each transmitter has an individually assigned, unique ID code. In order to start opera-
tion, the receiver must be linked with the ID code of the transmitter to which it is being
paired. Once the link is made, the ID code is stored in the receiver and no further link-
ing is necessary unless the receiver needs to be used with another transmitter.
Link procedure
1
Bring the transmitter and the receiver close to each
OTHER
2
Turn on the transmitter.
3
Turn on the receiver.
4
Push the tactile switch of the receiver.
When the link is complete, the LED in the receiver
changes to solid green.
When the ID cannot be read due to the surrounding
environment, try reading it with the transmitter and re-
ceiver antennas touching.
Connectors
4 :CH4 servo(CH4)
3 :CH3 servo(CH3)
2 :Throttle servo(CH2)
1 :Steering servo(CH1)
B/C :Power connector/DSC connector
No signal reception Red : On
Receiving signals Green: On
Receiving signals, but ID is unmatched. Green: Blink
Unrecoverable failure (EEPROM, etc.) Red and Green turn on alternately
LED status vs receiver's condition:
Precaution:
)F
ｎ Warning
ｊ After the linking is done, please cycle receiver power and check if the receiver to be linked is really
under the control of your transmitter.
ｌ Do not perform the linking procedure with motor's main wire connected or the engine operating as
IT
*Please refer the table below for LED status vs receiver's condition.