Initial set-up, Preparations (transmitter), Display when power switch turned on) – Futaba 4PKS 2.4GHz User Manual
Page 35

When radio waves are not being emitted when
turned on by display switch and when the
DSC function is used, "DISP" is displayed.
"RF"
When FASST-C2
"C2"
35
In
itial S
e
t-
Up
Before setting the Transmitter functions, check and set items 1 to 5 below.
Initial Set-Up
Preparations (Transmitter)
(Display when power switch turned on)
When the power switch is turned on, the currently selected model number is displayed.
Check if this number is the model number you want to set-up. To change the model
number, use the Model Select function (See page 100).
(Start screen)
Turn on the transmitter power.
The model number is displayed.
1.RF Output Check
If signals are output normally, RF output monitor "RF" will be displayed on the screen.
If "RF" is not displayed, contact your Futaba dealer.
When radio waves are not being emitted when turned on
by display switch and when the DSC function is used,
"DISP" is displayed.
2.Rx Type Check
The T4PKS transmitter can use the Futaba 2.4GHZ R603FS/FF. However, there are two
types of Futaba 2.4GHz receivers for vehicles: "C1" type and "C2" type. The R603FS
and 603FF are "C1" type. The R614FF supplied with the
4PKS set as standard is the "C2" type. Check that the setting
matches the receiver being used. For example, when using the
R614FF, the receiver type must be set to FASST-C2 and when
using an R603FS or R603FF, the receiver type must be set to
FASST-C1. If the setting is wrong, change it using the RX/SX
type select function (page 46).