Futaba 4PKS 2.4GHz - Manual (Page 106)

Communication port
(interior left side)
Cover
ESC receiver connector
Connecting ESC receiver
connector to the transmitter
Communication port
MC402CR MC950CR
MC602C
MC851C
106
Fu
n
c
tio
n
(Opening Screen)
MENU 1
Press t he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t he button
* W h e n t h e d ire c t c all but to n
is set, the setup screen is also
called by the following method:
-When the T4PKS battery voltage drops, the display switches to low battery display.
Therefore, use this function when there is ample battery capacity remaining.
-Also connect the battery at the ESC side.
ESC Link Function "MCLNK"
This is a special function which lets you set the contents of the Link software which per-
forms Futaba speed controller (ESC), MC950CR, MC851C, MC602C, MC402CR, etc.
variable frequency and other data changes by PC at the T4PKS transmitter. However,
some data changes require a PC and Link software.
This function is used by connecting ESC directly to the transmitter. The T4PKS power
switch is used at the display side. Use the various optional servo extension cords according to
the distance between the transmitter and ESC.
The last data read from ESC to T4PKS or the last data written from T4PKS to ESC is saved
to the T4PKS. Since the data for each model memory can be saved, the data of up to 40 mod-
els can be saved.
ESC Link Function "MCLNK"