Flintec FT-15D - Manual (Page 17)

FT-15(D) Technical Manual, Rev. 1.02 August 2010 Page 17 of 52
Second weighing cycle without printing first weighing label (parameter 045=0):
Steps Vehicle Position Description
There is no vehicle
on the weighbridge.
(Unloaded Scale) If the indication is not 0 kg, press the
key before loading the scale in the
instrument ready status.
[ 0 kg ]
Vehicle is parked on
the scale and the
engine is stopped. Load the scale. [ 28680 kg ]
Press the key to start the second
weighing cycle.
[ Second ]
Message will be displayed for 1 second.
[ V. Id ]
[
584 ]
Enter the vehicle ID numerically to select
the first weighing data from the temporary
memory.
Press the key.
[ First ]
[ 9760 kg ]
The first weight in the memory will be
displayed. Press the key to go to
the next step
[ Id1 ]
[
78 ]
Press the key to select from the ID
memory or press the key for a
numeric entry, if this entry is defined for the
second weighing (refer to parameter [043]).
Press the key.
[ Id2 ]
[
22 ]
Press the key to select from the ID
memory or press the key for a
numeric entry, if this entry is defined for the
second weighing (refer to parameter [044]).
Press the key.
[ Print ]
[ 28680 kg ]
If the vehicle has finalized the weighing
process, press the key to save and
print the weighing result.
[ Unload ]
[ 28680 kg ]
Message appears until the scale gets
unloaded.
Vehicle is on the
scale + the displayed
weight is stable.
Vehicle leaves the
scale. Unload the scale. [ 0 kg ]
If the displayed weight is less than 20e or
the key is pressed, FT-15 returns to
the instrument ready status.