Flintec FT-15D - Manual (Page 15)

FT-15(D) Technical Manual, Rev. 1.02 August 2010 Page 15 of 52
First weighing cycle without printing first weighing label (parameter 045=0):
Steps Vehicle Position Description
There is no vehicle
on the weighbridge.
(Unloaded Scale) If the indication is not 0 kg, press the
key before loading the scale in the
instrument ready status.
[ 0 kg ]
Vehicle is parked on
the scale and the
engine is stopped. Load the scale. [ 9760 kg ]
Press the key to start the first
weighing cycle.
[ First ]
Message will be displayed for 1 second.
[ V. Id ]
[
584 ]
Enter a vehicle ID number numerically (up
to 6 digits) as a first weighing code.
Press the key.
[ Id1 ]
[
78 ]
Press the key to select from the ID
memory or press the key for a
numeric entry, if this entry is defined for the
first weighing (refer to parameter [043]).
Press the key.
[ Id2 ]
[
22 ]
Press the key to select from the ID
memory or press the key for a
numeric entry, if this entry is defined for first
weighing. (refer to parameter [044]).
Press the key.
[Save W ]
[
9760 kg ]
If the vehicle has finalized the weighing
process, press the key to save the
weighing result.
[ Unload ]
[
9760 kg ]
Vehicle is on the
scale + the displayed
weight is stable.
Message appears until the scale gets
unloaded.
[ 0 kg] Vehicle leaves the
scale. Unload the scale.
If the displayed weight is less than 20e or
the key is pressed, FT-15 returns to
the instrument ready status.

Press the key to cancel the first weighing cycle.

If the vehicle ID already exist in the first memory the [Change ] message will be displayed.

Go to the temporary first weighing memory to delete the first weighing record.

[Code FL] message appears, if the temporary first weighing memory is full. Check the memory for records
which can be deleted or wait until any second weighing cycle to free memory for a new 1 st weighing.