EVCO EVC30S40J7XXX09 - Manual (Page 5)

5/13
1.11. Displaying board temperature
To access the procedure if probe 2 is enabled
• Press the [B3] key, the Pb2 label will appear on the display.
• Turn the encoder clockwise within 15 seconds in order to select the Pbb label.
To access the procedure if probe 2 is not enabled
• Press the [B3] key, the Pbb label will appear on the display.
To display the board temperature value
• Press the [ENCODER] button.
To exit the procedure
• Do not operate on the keyboard for 15 seconds
or
• Press the [ENCODER] button to go back to display of the Pbb label.
• Press the [B3] key or do not operate on the keyboard for 15 seconds
1.12. Displaying board temperature alarm
To access the procedure if probe 2 is enabled
• Press the [B3] key, the Pb2 label will appear on the display.
• Turn the encoder clockwise within 15 seconds in order to select the Ht label. If no
temperature is recorded, the label is not present.
To access the procedure if probe 2 is not enabled
• Press the [B3] key, the Pbb label will appear on the display.
• Turn the encoder clockwise within 15 seconds in order to select the Ht label. If no
temperature is recorded, the label is not present.
To display the board temperature alarm maximum value
• Press the [ENCODER] button.
To exit the procedure
• Do not operate on the keyboard for 15 seconds
or
• Press the [ENCODER] button to go back to display of the Ht label.
• Press the [B3] key or do not operate on the keyboard for 15 seconds