EVCO EPV4TBR Hardware manual - Manual (Page 14)

Evco S.p.A. Vtouch | Hardware manual ver. 1.01 | Code 114VTOUHWE01
page 14 of 22
Modbus Baudrate - - - - - - - - - 9600
Modbus communication baud rate (reserved)
1200 = 1,200 baud
2400 = 2,400 baud
4800 = 4,800 baud
9600 = 9,600 baud
19200 = 19,200 baud
28800 = 28,800 baud
38400 = 38,400 baud
57600 = 57,600 baud
Modbus Bit Stop - - - - - - - - - 1 bit
Modbus communication stop bit number
(reserved)
4.4. Configuring a device through the interface
Operate as follows:
1. Switch off the power supply of the device and of the interface.
2. Connect the device to the interface through the CAN port; look at chapter 3 (ELECTRICAL CONNECTION).
3. Switch on the power supply of the device and of the interface.
4. Operate on the interface to set parameter Network Node; look at chapter 4 (CONFIGURATION).
Parameter Network Node belongs to the CAN Network submenu.
According to the default settings, the CAN node’s address of a controller has value 1 (so operate on the interface to set parameter
Network Node to [1] 1) and the CAN node’s address of an expansion has value 2 (so operate on the interface to set parameter
Network Node to [2] 2).
5. Keep pressed 2 s buttons LEFT and ENTER of the interface: the display will show the Network Status menu:
Network Status (CAN)
address status more . .
local 99 ok > >
node 1 1 ok > >
node 2 2 ok > >
node 3 0 - > >
node 4 0 - > >
node 5 0 - > >
node 6 0 - > >
6. Press and release button UP or button DOWN to select the device.
7. Press and release button ENTER: the display will show the device’s Main menu.
8. Operate as indicated in paragraph 4.2 (Configuring the interface).
Switch off the power supply of the device and then switch it on after the modification of the configuration.