EVCO EPV4TBR Hardware manual - Manual (Page 13)

Evco S.p.A. Vtouch | Hardware manual ver. 1.01 | Code 114VTOUHWE01
page 13 of 22
Parameters Buzz On Key 0 2 - - - 2
Modality to use to utter the beep while pressing
an area of the user interface
0 = the beep is never uttered
1 = the beep is always uttered
2 = the beep is uttered only if the area
is sensitive
Parameters Print Frame 0 1 - - - 0
Showing frames instead small size pages
1 = yes
CAN Network MyNode 1 127 - - - 99 Local (or of the interface) CAN node’s address
CAN Network Master - - - - - - - - - YES The interface always works as master
CAN Network Baud - - - - - - - - - Auto
CAN communication baud rate
20K = 20,000 baud
50K = 50,000 baud
125K = 125,000 baud
500K = 500.000 baud
Auto = the interface recognizes the baud
rate automatically, on condition
that it is one of the those
mentioned above
One suggests modifying the value of the
parameter and assign each device in the network
the same baud rate.
CAN Network Net Timeout 1 240 s 5
Remote (or of the devices in the network) CAN
communication time-out (after this time without
CAN communication with a device, this will be
excluded by the network)
CAN Network Network Node [1] 1 [32] 127 - - - - - -
Remote (or of the devices in the network) CAN
nodes’ address; example for [1] 2:
[1] = node
2 = node’s address
Modbus Address 1 247 - - - 1 Modbus address (reserved)
Modbus Parity - - - - - - - - - even
Modbus communication parity (reserved)
none = no parity
odd = odd
even = even