List of configuration parameters – EVCO EPV4TBR Hardware manual User Manual
Page 11
Evco S.p.A.
Vtouch | Hardware manual ver. 1.01 | Code 114VTOUHWE01
page 11 of 22
7.
Press and release button ENTER: the display will show the Main menu.
To gain access a submenu operate as follows:
8.
From step 4, press and release button UP or button DOWN to select the submenu.
9.
Press and release button ENTER.
The access to the CAN Network submenu is protected by password.
To gain access to the CAN Network submenu operate as follows:
10.
From step 4, press and release button UP or button DOWN to select the submenu CAN Network.
11.
Press and release button ENTER.
12.
Press and release again button ENTER.
13.
Press and release over and over again button DOWN to set “-19”.
14.
Press and release button ENTER.
To modify a configuration parameter belonging to the Parameters submenu, to the CAN Network submenu or to the Modbus submenu operate as
follows:
15.
From step 9, press and release button UP or button DOWN to select the parameter.
16.
Press and release button ENTER.
17.
Press and release button UP or button DOWN to modify the value.
18.
Press and release button ENTER to confirm the value.
19.
Press and release button ESC to go back to the Main menu.
To modify the display’s contrast operate as follows:
20.
From step 4, press and release button UP or button DOWN to select the Contrast submenu.
21.
Press and release button ENTER.
22.
Press and release button UP or button DOWN to modify the value.
23.
Press and release button ENTER to confirm the value.
24.
Press and release button ESC to go back to the Main menu.
To modify the real date and time:
25.
From step 4, press and release button UP or button DOWN to select the item Real date and time.
26.
Press and release button ENTER.
27.
Press and release button UP or button DOWN to modify the value.
28.
Press and release button ENTER or button RIGHT to confirm the value and modify the following field.
29.
Repeat steps 26 and 27.
30.
Press and release button ESC to go back to the Main menu.
To quit the procedure:
31.
Press and release over and over again button ESC: possible modifications will not be saved.
Switch off the power supply and then switch it on after the modification of the configuration.
4.3. List of configuration parameters
Submenu
Parameter
Min.
Max.
Unit
Default
Description
Parameters
Date Char
Separator
- - -
- - -
- - -
/
Date separator (ASCII character)