Digilent 410-182P-KIT - Manual (Page 3)

Nexys3 Reference Manual
Doc: 502-182 page 3 of 22
JTAG (both jumpers loaded), and board power is cycled. The FPGA will automatically reject any .bit
files that are not built for the proper FPGA.
After being successfully programmed, the FPGA will cause the "Done" LED to illuminate. Pressing the
Reset button at any time will reset the configuration memory in the FPGA. After being reset, the
FPGA will immediately attempt to reprogram itself from one of the PCM devices if the J8 Mode jumper
is set to BPI or SPI mode.
Adept
USB Port
Power
Switch
USB HID
Host Port
Power
Jack
JTAG
Header
MODE
Jumper
Power
Good LED
Done
LED
Reset
Button
Power Select
Jumper
LEDs Slide switches Push buttons
7-seg
Display
USB
UART
VGA
Port
10/100
Ethernet
Pmod
Connectors
VHDC
Conncector
Digilent's Adept software offers a simplified programming interface and many additional features as
described below. The Adept USB port is fully compatible with all Xilinx tools, including the iMPACT
programming software. The Adept features are always available, regardless of how the FPGA was
programmed.