Comtrol Multiport Modems Windows 98 - Manual (Page 27)

Installing Modems and Adding Serial Printers 27
RocketModem Reconfiguration
15. Click Close to exit the Modem Properties window.
16. Reboot the computer. The RocketModem configuration utility automatically
runs on startup and uploads the RocketModem firmware.
RocketModem
Reconfiguration When you first install a RocketModem, the PC automatically launches the
RocketModem Configuration program. To access this program after initial
installation, follow these steps:
1. Select Start > Programs >
Comtrol RocketPort
RocketModem >
RocketModem Config.
The RktMCfg window
appears:
2. For each RocketModem
installed, verify that the
appropriate box is checked.
Note: Each RocketModem
must be designated as
a RocketModem on this screen in order for the Reset option (
Using
RocketModem Reset (rktreset.exe) on Page 44) to recognize the board.
3. Use the droplist to select the country or geographic region where the
RocketModem will be used.
4. Click OK to exit this program. Your changes take effect immediately. No
reboot is necessary.
Note: This option simply identifies the adapter as a RocketModem and specifies
the telco area where it will be used. You must also use the Windows Modems
applet to install and configure the modem software. For more information,
see
Installing Modems on Page 21.